Comfortz Awning Panels

[Alpy Days!]

Hello!
We are planning on investing in a set of Comfortz awning panels - I know alot of folk on here have them and swear by them.
My question is regarding pegging them down at the bottom.....we seem to always end up parked on gravel or even concrete rather than grass so knocking pegs into the ground is sometimes impossible - if the panels are left unpegged, does it leave the awning a bit flappy/unsatisfactory? Or does it not matter too much?
Nick at Comfortz been very helpful but he does suggest pegging down is a must......
Cheers
AlpyDays!

 

[Loz]

We use the Peggy peg screw in pegs and drive them in with a small battery drill, they also do aluminium pegs you hammer in and unscrew out.

We also have their pads for the awning legs.

I would not put them or the awning out without fixing them down.
If its on concrete you may have to forego the side and just use the awning with some water weights..

We put the peg through the reinforced plastic ring on the skirt and screw down and then hook the elastic toggle from the panel onto the the little hook.