Buy all your VW California Accessories at the Club Shop Visit Shop

Bed Extension Support Arm

Tractorboy007

Tractorboy007

VIP Member
Messages
7
Location
Essex
Vehicle
T6 Ocean 204
Hi all.

Was wondering if anyone could help me with finding a solution to an issue where the rubber grommet holding the bed extension support arm (item no 32 on the attached parts diagram) has sheared off and therefore the arm falls out of the hole (not the end of the world but abit annoying!)

Tempted to go back to VW but I’m not sure it will be covered under warranty.

Pretty sure I could find an electrical rubber grommet replacement from somewhere but not sure how to get it into the hole along with the arm.

Just wondering if this has happened to anyone else and if they found a fix.

Thanks.

C330233E-290C-4048-ABE4-13DAB2A3F337.jpeg
F59E8B7C-ED07-46BD-8B8E-51CD939B8006.jpeg
 

This should do the trick.

Either that or OPG012, I can't remember which one I used when I was doing my wee chaise longue/second strut mod.

Very simple to replace. Put the grommet in the hole first then slide the end of the strut through the hole in the grommet. A little bit of silicone grease can help if you need it.
 
Thanks a lot buddy. Will give it a go. Interested to hear more on your chaise longe mod now though?
 
Impressive.

Thanks for your help. Ordered a set of both grommets so will give them a try


Sent from my iPad using Tapatalk
 
Back
Top