Sound from front window scuttle when driving over 50mph

[MrT-6California]

I just had my window replaced by the dealer, and now there is a sound from my front window scuttle (only when I drive faster then 50mph).
My dealer is 100km away, so I would like to fix it myself if possible.
As a temp solution I put some rubber in between the front window scuttle (You can see them on the picture, the brown rubbers) which fixes the issue, but of course I would like to fix it for real.

Anybody an idea what could be causing it ? And how to fix it ?

thanks.

 

[Perfectos]

The plastic scuttle panel clips into clips under the window. Push fit

Removing tray underneath wipers to access grommet in engine bay

I'm trying to run a cable from inside the cabin to the engine bay. I've read there's a grommet on the passenger side of the engine bay that you can push wires through from underneath the glovebox. Thing is, the tray underneath the wipers is in the way of accessing this grommet (which is behind...

vwcaliforniaclub.com

try pushing the panel toward the van ! (Under the windscreen)

Edit: the bottom lip that you have the plastic tube under should sit flat to the body panel and tight to the rubber seal.

is there a gap at the bottom of the screen between screen and scuttle panel ?

looks like yours is not fitted correctly see photos below excuse the dirt
Photo 1 - drivers side screen junction
photo 2 - bonnet up looking along the panel (tight to rubber seal)
photo 3 - seal peeled back to show panel sits below seal

 

[MrT-6California]

Thnks Perfectos,

The plastic scuttle panel clips into clips under the window. Push fit

Removing tray underneath wipers to access grommet in engine bay

I'm trying to run a cable from inside the cabin to the engine bay. I've read there's a grommet on the passenger side of the engine bay that you can push wires through from underneath the glovebox. Thing is, the tray underneath the wipers is in the way of accessing this grommet (which is behind...

vwcaliforniaclub.com

try pushing the panel toward the van ! (Under the windscreen)

Do you mean towards the engine ?

Edit: the bottom lip that you have the plastic tube under should sit flat to the body panel and tight to the rubber seal.

There is definitly some space between the body panel and the scuttle.
And there is 1 or 2 mm space to the rubber seal.

is there a gap at the bottom of the screen between screen and scuttle panel ?

What do you mean, the window screen ? There is no space between the window screen and scuttle panel.

 

[MrT-6California]

Thanks for the pictures @Perfectos, that helps...

 

[MrT-6California]

@Perfectos
Do you have a side picture of your seal... your picture doesn't look like mine at all..

 

[MrT-6California]

 

[Perfectos]

View attachment 117901

That’s a normal seal same as mine , just sits over the edge of the upturn

 

[Perfectos]

Do you mean towards the engine ?

top edge of the scuttle, bottom edge of windscreen (the clips can only be seen when the scuttle is removed)