GC 600 Table leg

[Steve Gray]

Hi.
Has anyone else noticed that the table leg on the GC600 leaves and impression on the floor? I have put a temporary fix in place using some rubber. The pressure / weight of the table seems to be pressing the floor covering and leaving an impression of the bottom of the table leg. Anyone else have this or have noticed it and what fix have you put in place?

 

[Jester]

Hi.
Has anyone else noticed that the table leg on the GC600 leaves and impression on the floor? I have put a temporary fix in place using some rubber. The pressure / weight of the table seems to be pressing the floor covering and leaving an impression of the bottom of the table leg. Anyone else have this or have noticed it and what fix have you put in place?

Best to get the mat as think the current floor finish is to soft.

 

[leeb]

Yup....we use a small piece of foam plumbing pipe insulation

 

[Nobard 33 French]

I installed 1 cm thick clipable tiles for Swimming pool (or SPA) to protect the floor and a small rubber piece under the foot of the table
This leaves a small mark but when I move the table foot, the mark disappears !
I try not to always leave the table foot in the same place...

 

[secret lemonade drinker]

That flooring looks like Lidl/Aldi Garage rubber Tiles??

 

[Nobard 33 French]

That flooring looks like Lidl/Aldi Garage rubber Tiles??

They look like it !
But these tiles are not PVC but foam made (50x50cm)
They are used for outdoor spa
I bought them from Gifi