Grand California Table

[CaliFortanaRed]

We finally got our table cut down, now far more practical.

View attachment 88434

View attachment 88435

Hello, I like your seat covers. Where did you get them plese?

 

[GS O'brino]

Got my table brackets 3D printed now ready to make my smaller table. Going 400x800 and an adjustable leg to allow it to also make a bed frame between the seats in due course.

View attachment 80434

Could you share the step files?

 

[Hammer]

Could you share the step files?

check post 110 I shared the file via google drive, alternative is go on the FB group there is an alternative design on there too.

 

[GS O'brino]

check post 110 I shared the file via google drive, alternative is go on the FB group there is an alternative design on there too.

Thanks

 

[jacksprat1962]

Got my table brackets 3D printed now ready to make my smaller table. Going 400x800 and an adjustable leg to allow it to also make a bed frame between the seats in due course.

View attachment 80434

These are great. Can I purchase or download the files and print myself?

 

[Parapalkocamper]

Hello everyone, even after 3 years of using the car, I still couldn't get used to the size of the table and for a year now we've been thinking about how to convert it. It's too big when traveling and we can't go to the back from the front seats except from the outside, while camping, if there are four of us, it's too small and there's no table for the front right seat. That's why I thought about some kind of pull-out system, but in the end I decided on a lower table top that swivels around the table leg and managed to implement the plan, which works perfectly. I also equipped it with a blocking system so that it can't open while driving. I recommend this solution to everyone, the factory one is ridiculous for this much money.

 

[G-A-R-Y]

Very good.

 

[bromleyxphil]

I only have a little to add to this comprehensive thread but I cut my table down and moved the leg back to allow it to be smaller. Hope the pictures show that if you take the leg off you can drop the leg back one full set of holes. This allows you to remove the little fixing bolt sockets from the unused holes mark the table and re drill to fix as original but further back.

Using second set of holes to mark new ones

Removing bolt fixings

All fixed in place



Still misses the bench seat when fully back

 

[Beast from the East]

Hi Stiinuus, I notice your not a VIP member and hence cannot receive private messages re the brackets.

Hi, sorry to jump on this thread, but my husband has asked if we could somehow get the bracket file so we can have them made up. Regards.

 

[Hammer]

Hi, sorry to jump on this thread, but my husband has asked if we could somehow get the bracket file so we can have them made up. Regards.

see post 110 i shared file on google drive