Sliding door not closing correctly.

[Todd]

I have had trouble closing the sliding door on my Ocean 6.1. The door seemed to have dropped and was not lining up with the catch. I have taken a closer look and used an allen key to tighten up the bolt from underneath. It now looks like the second photo, does this look correct or is there something missing?

 

[Perfectos]

there is a nut missing from the top of the threaded part

 

[Perfectos]

Take a photo of the top and
bottom roller
And a photo of the gap around the door when closed.

If the door drops it will damage the bodywork (mid rail ) where the centre hinge hits the bodywork on closing.

 

[Todd]

there is a nut missing from the top of the threaded part

Thank you for your reply, I did think that, but wasn’t sure. Do you know if I need a locking nut?

 

[Perfectos]

Photo of missing nut

 

[Todd]

The bodywork fortunately is okay!

 

[Todd]

Photo of missing nut

View attachment 137163

Thank you!

 

[Jerry999]

Just felt the need to check mine - all looks good.

 

[Perfectos]

Just felt the need to check mine - all looks good.

View attachment 137164

That's as it should be , a much clearer picture (I robbed one from a tinternet photo)

 

[Todd]

Just felt the need to check mine - all looks good.

View attachment 137164

Thank you for photo, as well as adding a bolt (which I think has been missing from new) I might need to tighten a bit more as I have more of the white showing underneath the spring,

 

[Jerry999]

Thank you for photo, as well as adding a bolt (which I think has been missing from new) I might need to tighten a bit more as I have more of the white showing underneath the spring,

Is this better?
It's about 14mm from the top of the bracket to the end of the thread.