Hill start/clutch slip

Cloudbreak

Cloudbreak

VIP Member
Messages
69
Location
Skipton
Vehicle
T6 Ocean 199 4 motion
I own a T6 2019 4motion DSG. On several occasions when climbing passes, recently in Italy after stopping for a short period on an incline I have been unable to engage drive when on hill assist. I have it in drive but have to rev the rpm, typically then wheel spinning off. On several occasions there has just been not engagement of drive.
Has anyone else experienced this on a DSG, is there a sequence I’m not following? Is this dual clutch wear? When this happens I have to dive for the hand break to prevent it rolling back. It’s concerning as it usually happens on a steep hill and incontrollable Hope someone can shed some light. Ps recent DSG oil change, engine oil and Haldex but happened last year in the Dolomites prior to this too..
 
There has been an update by VW for the T6 DSG gearbox , check with dealer if yours has had it.

It should be applied by the dealer when servicing the van
 
Old threads



Multiple Thread search Results

 

Similar threads

Back
Top