Custom build - 2020 Westfalia Club Joker 4Motion - Offroad build thread

[Webbah_in_Switzerland]

It’s now solar noon without clouds. As the Winter sun is low in the sky this test proves that the rear and side panels were worth it. Double the power va the flat panels on the roof. So far so good!

Sent from my iPhone using Tapatalk

 

[Maeve]

Hey Webbah...enquiring minds want to know...well maybe just me enquiring...how do you handle the penthouse mattresses, have you found someone to source fitted sheets for each section of the Froli mattresses or, like me are you using a topper on top of them?

 

[Webbah_in_Switzerland]

Hey Webbah...enquiring minds want to know...well maybe just me enquiring...how do you handle the penthouse mattresses, have you found someone to source fitted sheets for each section of the Froli mattresses or, like me are you using a topper on top of them?

Haha! The struggle “was” real. I took measurements and found fitted sheets that work. Bought 4 of them and rotate. Some are cotton for summer and some are thicker flannel type for winter.

Sent from my iPhone using Tapatalk

 

[Webbah_in_Switzerland]

Hey Webbah...enquiring minds want to know...well maybe just me enquiring...how do you handle the penthouse mattresses, have you found someone to source fitted sheets for each section of the Froli mattresses or, like me are you using a topper on top of them?

I also upgraded the mattress to a thicker one. It’s in this thread for reference. World of a difference and I hate toppers. 7cm thick.


Sent from my iPhone using Tapatalk

 

[Maeve]

I also upgraded the mattress to a thicker one. It’s in this thread for reference. World of a difference and I hate toppers. 7cm thick.


Sent from my iPhone using Tapatalk

Did 7cm with the sheets fit on the "bottom half" when you slid the top half back? That sounds interesting...I will try to find where you did that...

 

[Webbah_in_Switzerland]

Did 7cm with the sheets fit on the "bottom half" when you slid the top half back? That sounds interesting...I will try to find where you did that...

I had him make that section in 2 layers. One 5cm and a 2cm top piece. That isn’t really needed though as although it’s a bit tight it slides back fine with both pieces. If I did it again I’d just go with the 7cm all around. I might even ask them to make that section again in 7cm.


Sent from my iPhone using Tapatalk