Graham Winders
Lifetime VIP Member
So I’ve been wanting to add the small additional under bench drawer to my Coast but I’m not willing to pay the extortionate prices for the parts. After a bit of thinking and rethinking I decided to make my own.
I made the drawer from some 12mm exterior ply, I repurposed the original blanking cover and purchased some heavy duty push to open drawer runners ( so I didn’t need to purchase a new front panel with the lever and lock.)
I also made a small section at the rear of the drawer to fit the tyre compressor which was originally strapped to the rear side corner of the bench.
The project cost me £20 in total for the runners as I already had the plywood in my garage.
Hope you like it.
I made the drawer from some 12mm exterior ply, I repurposed the original blanking cover and purchased some heavy duty push to open drawer runners ( so I didn’t need to purchase a new front panel with the lever and lock.)
I also made a small section at the rear of the drawer to fit the tyre compressor which was originally strapped to the rear side corner of the bench.
The project cost me £20 in total for the runners as I already had the plywood in my garage.
Hope you like it.
